list plate
Machine statistics - Plate and Media Type Tracking
Some of the same fault statistics are broken down by both bay number and media type.
A fault will be counted each time it occurs. Therefore, a fault will be counted each
time "resume" is selected without fixing the fault.
Picked - number of plates actually picked (or "grabbed") ("set state bstats pp", "set state mstats pp")
Loaded - number of times the bay has been loaded (not including opened) ("set state bstats ld")
Opened - total number of times the bay has been opened (not including loaded) ("set state bstats op")
Opened Susp - number of times the bay has been opened while the picker is suspended on the bay ("set state bstats opns")
Exposure Changed - number of times the bay's exposure has been actually changed, the new exposure is different than the old one ("set state bstats ec")
Pre-Img Faults - total number of errors while picking and loading ("set state bstats pif")
Bay Opened Faults - number of errors while picking and loading a bay that has just been opened ("set state bstats pib")
Img Faults - number of errors that have occured after plate loading and before unloading, i.e. edge detection, stroke flattening, imaging, etc. ("set state bstats if")
Post-Img Faults - number of errors while unloading and ejecting to processor. Note that faults occuring once the plate has entered the processor will not be counted. ("set state bstats aif")
All
list plate
Bay stats values may be cleared using SET STATE BSTATS <bay#>
Plate stats may be cleared using SET STATE MSTATS <media#>